On 04.05.2011 00:41, Henning Scholland wrote:
Am 04.05.2011 00:08, schrieb Felix Hartmann:
On 04.05.2011 00:05, Henning Scholland wrote:
Am 03.05.2011 23:37, schrieb Felix Hartmann:
On 03.05.2011 23:27, Minko wrote:
Yes, that is also a good alternative, 0x01 as a transparent line and on top either 0x10f01 or 0x10f02
you cannot make a line transparent by omitting it from the typfile, but go ahead and do your tries.
Yes, but you can use a transparent png-file ;)
Henning
And then you have streetnames shown, but no street.... If you remove the streetnames on 0x01, you remove streetnames on the broken Oregon, edge 800, gpsmaps 62 series, for all maps (until hard reset)
The streetnames should be at 0x01, because this is rendered on top. 0x10f01 or 2 were rendered below and will be visible because of 0x01 is transparent.
Henning
What is rendered on top and what not depends on GPS Firmware. For old GPS it is opposite to Mapsource 6.16 if you use a .TYPfile. If you omit entries from typfile, it changes order. There are quite a lot of variables, and in general stuff on top of each other is stupid. Better use transparency wisely, it's much more powerful than layers or top/down drawings, and it works consitstent on all GPS except Zumo (all that is all that are able to use .TYP-files).